Article #ETM183 ETM® System v5.1 Update 10 remedies the possibility of inaccurate SMDR resolution inhigh call volume environments as well as other issues and also includes all changesfrom Updates 1-9. It is an update to v5.1 of the ETM System that will apply to somecustomers. See the attached PDF for...

Article #INS393 The attached document provides the correct diagram for the SMDR Y Cable and thepinout for the Aux and Console ports on the ETM 2100/3200 Card. This Y cable diagramreplaces the one on page 163 of the ETM® Platform v3.0 Installation andConfiguration Guide and on page 127 of the...

Article #INS318 The attached document shows common cables required to communicate to ETM® Appliancesvia the console port, SMDR connections to the auxiliary port, and T1 connections tothe T1 ports. Click Download for more Details:

Article #INS225B Synopsis When a Y cable is used to connect an ETM® Communications Appliance to a PBX, the Appliance assumes that the other device connected to the Y cable (e.g., a computer) is providing the handshake signal to request receive data. If the other device is powered off or is...

Knowledge Base Article #APP247B Knowledge Base Article #APP247B Supported PBX SMDR Port Settings Synopsis This technical bulletin provides the PBX SMDR/CDR port settings supported by the ETM® Appliances. Versions Affected ETM System v4.0 More Information The ETM® System supports the following PBX SMDR port settings: SMDR Baud Rate—300, 1200, 2400, 4800, 9600,...